Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Brake Master Cylinder leak after pushing on it
#9
(04-06-2014, 12:25 PM)welshpug Wrote: unless your turbo inlet is 3" its a waste.

Completely incorrect.

If your turbo WAS 3 inch and you ran 3 inch pipe for even 1/3 of that distance, it would massively effect performance, as the pipe gets smaller the problem gets worse...as soon as you run a long intake pipe on any turbo you introduce chronic air drag / restriction...and it WILL effect power / turbo lonetivity...

Sadly with the blower down the back its almost impossible to get a big enough pipe to it without issues...I'm ocd about things touching / rubbing the bulkhead mind...

All you can do is open filter it, or if that's to far for you / daily driver, just run the biggest and shortest pipe you can...
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |

[Image: sigi-2.png]
Reply
Thanks given by:


Messages In This Thread
Re: RE: Brake Master Cylinder leak after pushing on it - by darrenjlobb - 06-06-2014, 06:56 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  HDi 23.8mm Master Cylinder - Where from? Alan_M 3 1,937 07-09-2016, 02:33 PM
Last Post: Alan_M
  23mm Master Cylinder with 266mm Brakes MY95 18 6,490 16-04-2015, 01:42 PM
Last Post: MY95
  Hdi master cylinder tysonbully2k12 0 1,213 24-02-2015, 04:43 PM
Last Post: tysonbully2k12

Forum Jump:


Users browsing this thread: 1 Guest(s)