21-05-2014, 01:36 PM
(This post was last modified: 21-05-2014, 01:37 PM by Rippthrough.)
As above, if you had to hammer them in there's probably corrosion under the stainless steel wear plates that the pads ride on, no wonder they were creaking, I'm surprised you haven't bent the backplates!
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.