Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
P2030 after some views (yes another)
#28
(16-04-2014, 06:27 PM)Poodle Wrote: Not at all mate, it's usually pretty hard to make measurements by eye from any picture lol.

Fair enough, just my eyes then lol.

Ah yeah, you did say further up, sorry i missed that before.

That almost sounds like something is blocking up the fuel line. Try disconnecting them and blowing them out from the engine bay end with an air line. Alternatively, could be down to power supply and regulation, ie the infamous brown relay.

Smoke from the dash..? From whereabouts, that doesn't sound good..? Confused

Yeah it is okay mate Smile

The smoke from dash turned out that the earth on gearbox was dodgy, it was hanging on by a thread and very loose, so sorted that with new connector.

We also have no more cutting out, it runs Big Grin

Yet to drive it but will hopefully be okay, it doesnt cut out anymore shortly after you start it..

I changed the fuel filter and fpr again for another one and more importantly had a brain wave, i took the camshaft sensor out yesterday and noticed it wasnt sat quite in. This being said i removed it, cleaned it and also checked the wiring and rewrapped it and then it struck up and stayed running..

I dont know if that was the fault or a dodgy wire i disturbed when moving it but it hasnt cut out since and starts better than mine know, literally flick the key and its running..

So thanks for all help guys and i have managed to figure another one out without pp Smile

After this got loads done to it i wasnt prepared to do without getting it to run right first, so next on my list is a damn bonnet the same colour as the car Smile
Reply
Thanks given by:


Messages In This Thread
P2030 after some views (yes another) - by mspdan - 23-03-2014, 08:33 PM
RE: P2030 after some views (yes another) - by mspdan - 16-04-2014, 09:05 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  parts exploded views pug306driver 1 944 16-04-2014, 09:43 AM
Last Post: kentiiboii

Forum Jump:


Users browsing this thread: 3 Guest(s)