10-04-2014, 06:37 PM
90 degrees is fine. With regards to loosening cam pulley bolts; it's not normally necessary, but if you're at a point where the belt wants to sit halfway between teeth then just do it to make life easier.
|
Just done the cambelt
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Just done the cambelt - by titch - 10-04-2014, 12:50 PM
RE: Just done the cambelt - by Toms306 - 10-04-2014, 01:25 PM
RE: Just done the cambelt - by Slam Wagon - 10-04-2014, 01:47 PM
RE: Just done the cambelt - by tigerstyle - 10-04-2014, 03:00 PM
RE: Just done the cambelt - by titch - 10-04-2014, 03:17 PM
RE: Just done the cambelt - by jamesgmg - 10-04-2014, 03:12 PM
RE: Just done the cambelt - by Toms306 - 10-04-2014, 04:20 PM
RE: Just done the cambelt - by titch - 10-04-2014, 04:25 PM
RE: Just done the cambelt - by Poodle - 10-04-2014, 06:37 PM
RE: Just done the cambelt - by welshpug - 10-04-2014, 07:10 PM
RE: Just done the cambelt - by Hec1872 - 05-07-2014, 05:30 PM
|
Users browsing this thread: 1 Guest(s)