Hi
Trying to remove the stat housing, but the whole lump, this ones ally but it'll replace a plastic one. Apart from a fuel pipe being run through the older ally one, I don't think there's any differences.
This came off fairly easily.....except the rear metal pipe that runs under the turbo. Does it even come out!? Sure I read on here its just push fit, but wont budge at all. Is it better to remove the rubber pipe from the plastic connector on the other end of the engine and leave it all attached? Not sure if theres room to manoeuvre the whole thing though.
Also, can I get a replacement gasket from factors or will it be a dealer only thing?
Cheers
Tom
Trying to remove the stat housing, but the whole lump, this ones ally but it'll replace a plastic one. Apart from a fuel pipe being run through the older ally one, I don't think there's any differences.
This came off fairly easily.....except the rear metal pipe that runs under the turbo. Does it even come out!? Sure I read on here its just push fit, but wont budge at all. Is it better to remove the rubber pipe from the plastic connector on the other end of the engine and leave it all attached? Not sure if theres room to manoeuvre the whole thing though.
Also, can I get a replacement gasket from factors or will it be a dealer only thing?
Cheers
Tom