04-04-2014, 11:12 AM
Hold it on using mole grips or clamps, mark the position so that it is in the middle. Mark where your middle screw will go. Mark the ends.
Take splitter off, drill pilot holes using small drill bit.
Cut off ends.
Clamp back on, postion correctly, get on your back and get screwing
You could just trim it off the car and then screw it in almost all the way around and then cut of the excess with it on the car. Use a good hack saw. You can determine the shape better with it on the car, follow the curve of the bumper.
Take splitter off, drill pilot holes using small drill bit.
Cut off ends.
Clamp back on, postion correctly, get on your back and get screwing
You could just trim it off the car and then screw it in almost all the way around and then cut of the excess with it on the car. Use a good hack saw. You can determine the shape better with it on the car, follow the curve of the bumper.