14-03-2014, 09:12 AM
(This post was last modified: 14-03-2014, 09:13 AM by sweeney1987.)
If it were me doing it id use an xud engine with all ancillaries, plumb in power steering etc.
Wiring wise i would remove each wire of the dw8, labelling as i go, starter alternator, water sensor etc etc. same for xud loom.
and wire dw8 loom to xud engine, and differences in plugs then(if theres even any) i would go back to xud loom and cut them off and wire into the dw8 loom
Wiring wise i would remove each wire of the dw8, labelling as i go, starter alternator, water sensor etc etc. same for xud loom.
and wire dw8 loom to xud engine, and differences in plugs then(if theres even any) i would go back to xud loom and cut them off and wire into the dw8 loom