03-03-2014, 10:34 AM
(03-03-2014, 10:21 AM)happypug Wrote:(03-03-2014, 09:10 AM)phil clark Wrote: Sorry about the delay, ive been away with work. Im now on holiday "ALL" week, so Asside from Thursday, pick a day, and time, and im here. Must Add, I own a hdi (T plate 1999) without a bsi box fitted, which operates on KWP 2000 protocols. It was one of the very first 306's fitted with the HDI Engine. Nothing goes through the CAN pins on the 16 pin plug connector, and the immo's located below the heater controls. Its a bit of a strugg to be fair, as it was owned by Peugeot as a demo car.
Hi. Where are you in Stafford? forward your phone no to arrange day/time. As far as I can understand your 2000 should work on mine, I need to know whats causing the intermittent start probs. Have tried a snap on diagnostic at my friends garage with no success. Cheers
Lol, i'll do you a map on google and link it to a private message. Im going to ask you a question. Do you have an Engine management light on?. PP2000 is basicley the same as all other systems, in that it reads fault codes. It does however provide stats on the Engine provided by individual sensors. Its a fueling issue "I THINK", unless you have an intermitant lack of compression. Be prepaired to write down a load of figures.