Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
High pressure oil feed line diameter
#4
I do not rush my projects Niall Rolleyes Better to do it properly once so it goes on and stays on than do it in properly and have to take it off again. Once I get an SD card reader for my new computer I will put a new project thread up to update you on the progress and the issues which have slown it down. Until then, shut it :p

(10-02-2014, 05:06 PM)Chris_90 Wrote: We'll guy who made mine up said it's quarter of an inch something like that and no idea on length get tape measure out and lay under car Wink

Bare in mind I need accurate info, no point getting it made up and it's too big leading to low pressure and a blown turbo <_< Also measuring the standard line is not possible because it is a solid steel line with bends and there is no way to get a tape measure by it. Not being pedantic, just in case a certain person says "Oh, you've had loads of answers and ignored all of them". You know who I am talking about Wink

Edit: Just in case anyone gets this thread in the "related threads" section:

http://306oc.co.uk/forum/thread-6498.html

It only tells me the outer diameter, not the inner one. I thought I was close to finding a solution but turns out to be a red herring.
Reply
Thanks given by:


Messages In This Thread
RE: High pressure oil feed line diameter - by 306Puggy - 10-02-2014, 05:46 PM
RE: High pressure oil feed line diameter - by Tom - 10-02-2014, 07:32 PM
RE: High pressure oil feed line diameter - by Tom - 10-02-2014, 09:53 PM
RE: High pressure oil feed line diameter - by Tom - 10-02-2014, 09:44 PM
RE: High pressure oil feed line diameter - by Tom - 10-02-2014, 10:18 PM
RE: High pressure oil feed line diameter - by Tom - 10-02-2014, 10:50 PM
High pressure oil feed line diameter - by td_dan - 13-02-2014, 02:29 PM
High pressure oil feed line diameter - by td_dan - 13-02-2014, 02:36 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Help repairing/replacing high pressure PAS pipe heyitsroth 2 1,709 03-01-2018, 11:53 AM
Last Post: welshpug
  Twin turbo high pressure oil feed setup. 205dtub 17 4,472 23-02-2015, 07:47 PM
Last Post: 205dtub
  auxiliary belt length with different power steering pulley diameter juz22 1 1,446 18-10-2014, 05:02 PM
Last Post: Niall

Forum Jump:


Users browsing this thread: 9 Guest(s)