06-02-2014, 06:57 PM
(This post was last modified: 06-02-2014, 07:04 PM by zx_volcane.)
Off the top of my head i think its a 16mm 12 sided socket
If you've got a 3/8" set, just try a few multipoints on till you get the right one
ARP recommended torque is 100 ft/lbs
Do them up in 3 stages, ie all to 33, then all to 66 the finally all to 100
Follow standard bolt pattern for tightening sequence
Probably a good idea to check the torque after a couple of heat cycles too.
Always use the arp fastener lube, and clean the threads out in the block with a tap
Too right
If you've got a 3/8" set, just try a few multipoints on till you get the right one
ARP recommended torque is 100 ft/lbs
Do them up in 3 stages, ie all to 33, then all to 66 the finally all to 100
Follow standard bolt pattern for tightening sequence
Probably a good idea to check the torque after a couple of heat cycles too.
Always use the arp fastener lube, and clean the threads out in the block with a tap
(05-02-2014, 10:19 PM)Tom Wrote: Heh well there you go kids, dont do everything you read on the internet!
Too right
![[Image: avatar_zpstlcgvhg8.jpg]](http://img.photobucket.com/albums/v363/toastmonster/avatar_zpstlcgvhg8.jpg){kind=avatar}
