24-02-2012, 09:50 PM
Dum-Dum Wrote:Lush mate, you not having the pistons machined down to drop the comp on this one?
As for engine paint hammerite is fine and a small pot will do a good few coats on a block.
Remember what rods are in this motor I only took material off the first one, the rods drop the compression since ive been forged....
And yeah, ill have to get some paint, everythings going wrong this week, so a bit scared to start on this incase somethings goes tits up now!
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
| #DervMafia |