Info on alloys

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Info on alloys

lolsteve Offline

Offline

Team Yobbo

Registered users - Donated

Registered users - Donated

Posts: 3,467
Threads: 186
Joined: Mar 2012
Reputation: 38
Location: Manchester
Car Model/Spec: MG ZR VVC

Thanks: 3
Given 21 thank(s) in 19 post(s)

#6

27-12-2013, 12:14 AM

Nimrods dont 'need' spacers depending on how good your beam is. I had nimrods on with 5mm spacers on the rear, only because on one side the arch trim was a bit loose and rubbed on the tyre a little bit the other side was perfectly fine though. That said a bit of spacing makes them look better too

[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Info on alloys - by willJspears - 26-12-2013, 11:44 PM

RE: Info on alloys - by Craigus - 26-12-2013, 11:53 PM

RE: Info on alloys - by willJspears - 26-12-2013, 11:55 PM

RE: Info on alloys - by cully - 26-12-2013, 11:57 PM

RE: Info on alloys - by willJspears - 27-12-2013, 12:01 AM

RE: Info on alloys - by lolsteve - 27-12-2013, 12:14 AM

RE: Info on alloys - by willJspears - 27-12-2013, 12:19 AM

RE: Info on alloys - by padge - 27-12-2013, 12:25 AM

RE: Info on alloys - by Dicky - 27-12-2013, 11:09 PM

RE: Info on alloys - by Martin306 - 27-12-2013, 11:22 PM

RE: Info on alloys - by Chris_90 - 27-12-2013, 07:42 AM

RE: Info on alloys - by willJspears - 27-12-2013, 09:23 AM

RE: Info on alloys - by Dum-Dum - 27-12-2013, 11:15 AM

RE: Info on alloys - by Matt - 27-12-2013, 11:16 AM

RE: Info on alloys - by willJspears - 27-12-2013, 11:52 AM

RE: Info on alloys - by lolsteve - 27-12-2013, 12:33 PM

RE: Info on alloys - by Jtrigga - 27-12-2013, 10:41 PM

Users browsing this thread: 1 Guest(s)