Silverzx's White 205 1.9 DT XUD

[silverzx]

Ha Ha I'm no good with wireing either lol and not sure about fans I'm just gonna make my own mounting point and get some slim fans on the raditor

Meh, choppy choppy and wiring to standard looms is always a good shout in my book!

usual solution is to lower and tilt the rad on a custom bracket bolted between the chassis legs, use slimline fans running off the original wiring and fit a 4" tall or thereabouts cooler behind the grille.

you need to retain some of the cowling so the slam panel doesn't flex and for the grille to fix to.

I have a perfectly sized FMIC for the job, just need to crack on and order some fans off eBay (I'll do that right now). Have plenty of bits of bracket strips etc for custom mounts.

Such a random collection of parts on this car haha. Gti valences, mardi gras seats, Roland garros steering wheel...

Peugeot parts bin special at it's best!

holy boschamoly...its on a lucas?! get ya act togetheir maaan!

Err, wanna come give us a hand? Really dreading doing it on my own! *Massive sigh*.

Whats confusing about the wiring?

The lot! I don't know where to start, feel free to reply/PM me guidance!

Looking at his attempt for the speakers, i'm going to say everything lol. :p

That could cause a boost leak, stick a bit of soapy water over it and give it some revs to see if it bubbles.

Exactly! Wiring radios, amps, subs, speakers and gauges is enough fun for me!

Soapy water eh, ok will give it a go!



Slight problem, my main beam & full beam have decided to become very temperamental since fitting the amp/sub. The wire that goes to the battery + is still firmly connected so can't see how that would be causing a problem. The side lights still work fine and flicking the stalk back and forth for a minute or two can sometimes fix it. Suggestions? I'm guessing either:

a) stalk is wearing out, making a bad connection
b) the positive from battery isn't mated as good as needed
c) the HID's are dying a slow death

Also if anyone local would be willing to give me some support through the Bosch fitment I'd happily reward them one way or another.