Silverzx's White 205 1.9 DT XUD

[silverzx]

Just stap it to the front of the bumper! It well fine

Cable ties are a Datsun tool, not a Pug tool..

FMIC is a bitch without GTi valances, you're lucky! haha.

Uhh, I'm guessing I have a GTi valance then!?

Wrote up a few things that need doing:

To Do
Fit & Fabricate plates for GT2052V
Adapt GT2052V actuator to boost controlled
Fit & Fabricate exhaust
Fit FMIC
Fit XUD9 box
Fit 11mm Lobb pump & timing belt
Fit speedo cable & stdt cluster with adapted loom (with rev counter)
Fit Stack EGT gauge & probe to exhaust manifold
Fit Stack boost gauge
Re-Wire radio with crimps
Wire junction box for gauge lights and power supplies
Lower the rear (Jamie plz <3)
Fit TA coilovers (awaiting part)
Wire up fog lights