What the actual f*ck???

[puglove]

Hello,
Please note that not all engines can have this mod fitted too and all wiring looms will differ which is why it has an extended
no quibble return and refund in full policy of 60 days not 7 days as required by ebay , gains will differ due to inbuilt tolerances/differences in engines.
Please check and see if it applies to your engine.
If you can locate the maf sensor or iat sensor then yes it will fit,
The maf is located on the thick air pipe that leads off the air intake housing
and will require testing with a simple voltmeter.


to test it do the following.
1:Turn ignition on but do not start the engine.
2:gently pull the plug with leads to remove it
3:check the voltages across the cables with a simple volt meter set on dc volts
4:just 1 pair will read around 5 volts
5:connect the red to this
6:connect the black to the other cable that you put the test lead on.
7:replace the plug

all done.


If you cannot replace with the mod in place then bare the correct wires back a little to connect.
If you get an ecu light come on then reset using the instructions.
If the mod fails you may need to snip the 5 volt cable that goes into the maf.the mod needs to remain connected to both cables , not the maf part of the cable that has been snipped.

The iat is usually located on the air filter housing or on the pipe just outside it
If you have the iat then pull of the leads and simply plug in.

Kind regards , trev