09-10-2013, 04:06 PM
Can't get good enough adhesion without stripping them back to bare steel, drilling the studs to seperate the two halves and having them sandblasted and the surface primed, tried it before.
Then you need 2 jigs to keep them lined up whilst it sets, some way of keeping some compression on the resin, etc. Bit of a pain in the arse, easier just to make them solid.
Then you need 2 jigs to keep them lined up whilst it sets, some way of keeping some compression on the resin, etc. Bit of a pain in the arse, easier just to make them solid.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.