01-10-2013, 10:14 PM
I need to change the timing belt on my peugeot 306 estate which is with 2.0 16v engine. I will change the whole timing belt kit and also the water pump. I have looked in haynes manual and in autodata about fitting the new belt, but i dont have the SEEM tool. I think i will use the finger metod, i will bend the belt at the front site, but i am confused from some things:
In autodata it says that you tenssion should be 45SEEMS than you rotate the engine and insert the lock pins and the tenssion should be 26 SEEMS and at the end it says you check the tension and it should be like 32-40SEEMS.
So do i need this whole thing or I can just adjust it so it can't bent more than 90* rotate the engine and just recheck the tension? Or tell me the right way...
Thx
In autodata it says that you tenssion should be 45SEEMS than you rotate the engine and insert the lock pins and the tenssion should be 26 SEEMS and at the end it says you check the tension and it should be like 32-40SEEMS.
So do i need this whole thing or I can just adjust it so it can't bent more than 90* rotate the engine and just recheck the tension? Or tell me the right way...
Thx