Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
help
#19
(13-09-2013, 11:49 AM)Tom Wrote: Run engine spray something flammable around the head/base of the inlet manifold if the engine revs up your inlet manifold gasket is leaking. Might be able to tighten them up but go easy they are so fragile its unreal.


so basically lift my bonnet turn over my car and spray lets easy easy start behind the intercooler and see if it revs higher??

as for turbo pipes im going to whip them off and see if i can see any holes when dipped in water see if that makes a differance
Reply
Thanks given by:


Messages In This Thread
help - by Dan306DT - 13-09-2013, 09:56 AM
RE: help - by underground375 - 13-09-2013, 10:00 AM
RE: help - by Dan306DT - 13-09-2013, 10:03 AM
RE: help - by Mac22 - 13-09-2013, 10:13 AM
RE: help - by Dan306DT - 13-09-2013, 10:16 AM
RE: help - by Mac22 - 13-09-2013, 10:18 AM
RE: help - by Dan306DT - 13-09-2013, 10:19 AM
RE: help - by Mac22 - 13-09-2013, 10:27 AM
RE: help - by Dan306DT - 13-09-2013, 10:51 AM
RE: help - by devils_fuel - 13-09-2013, 11:12 AM
RE: help - by Dan306DT - 13-09-2013, 11:16 AM
RE: help - by adamm306 - 13-09-2013, 11:17 AM
RE: help - by Dum-Dum - 13-09-2013, 11:23 AM
RE: help - by Dan306DT - 13-09-2013, 11:24 AM
RE: help - by devils_fuel - 13-09-2013, 11:28 AM
RE: help - by Dan306DT - 13-09-2013, 11:39 AM
RE: help - by Tom - 13-09-2013, 11:49 AM
RE: help - by Dan306DT - 13-09-2013, 12:03 PM
RE: help - by adamm306 - 13-09-2013, 11:50 AM
RE: help - by Tom - 13-09-2013, 12:27 PM
RE: help - by Dan306DT - 13-09-2013, 12:47 PM
RE: help - by Tom - 13-09-2013, 12:56 PM
RE: help - by Dan306DT - 13-09-2013, 12:57 PM
RE: help - by ADV_93 - 13-09-2013, 01:05 PM
RE: help - by Dan306DT - 13-09-2013, 01:09 PM
RE: help - by ADV_93 - 13-09-2013, 01:56 PM
help - by Dan306DT - 13-09-2013, 01:57 PM
RE: help - by 4WayDiablo - 14-09-2013, 07:44 AM
help - by Dan306DT - 14-09-2013, 09:06 AM
RE: help - by Tom - 14-09-2013, 10:08 AM
RE: help - by Dan306DT - 17-09-2013, 06:26 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)