25-07-2013, 11:41 AM
A whole lot of grinding and dremmeling later I finally got the 18mm spanner in the hole!
![[Image: IMG_20130725_114439_zps6cafad59.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20130725_114439_zps6cafad59.jpg)
spanner kept flying out and at one point flew so far I couldnt find it. Turned out to be stuck around the engine mount area! Cable tie kept it in whilst I used a 19mm wheel bar to take off the bolt. Then went down to 18mm ratchet once it was easy enough.
Got the bolt out. Strut brace on. Bolt did up perfectly!
SORTED!
THANKS GUYS! XXX
![[Image: IMG_20130725_114439_zps6cafad59.jpg]](http://i1184.photobucket.com/albums/z327/srowell3/IMG_20130725_114439_zps6cafad59.jpg)
spanner kept flying out and at one point flew so far I couldnt find it. Turned out to be stuck around the engine mount area! Cable tie kept it in whilst I used a 19mm wheel bar to take off the bolt. Then went down to 18mm ratchet once it was easy enough.
Got the bolt out. Strut brace on. Bolt did up perfectly!
SORTED!
