11-02-2012, 07:32 PM
Right well I set out this morning to change the drivers side CV joint & also fit a new rear engine mount, (just bought a new cradle and swapped them over to make it easier) And that all went fine.Come to putting it back together and thats when it went tits up, after putting the driveshaft back into the gearbox I went to put in the gearbox oil after putting a litre in it starts to piss out of the gearbox where the driveshaft enters.
It was in as far as it would go so thats not the problem, however I didnt replace the oil seal with a new one ?
Is this going to be the problem ? Torn oil seal? Just need to know if there is going to be any other posabilitys to what could have happened, it doesn't pour out.... Just a slow but constant trickle.
Anyone shed some light onto how the oil seal goes in and out, Just take a screw driver to get it out ?
Is this all that is needed. http://www.ebay.co.uk/itm/PEUGEOT-306-DR...563c3d70eb
Like this^
I would Get one from the local pug garage, Is there anything else because i cant see how that would seal it ?
If anyone could Enlighten, me then please do!
It was in as far as it would go so thats not the problem, however I didnt replace the oil seal with a new one ?
Is this going to be the problem ? Torn oil seal? Just need to know if there is going to be any other posabilitys to what could have happened, it doesn't pour out.... Just a slow but constant trickle.
Anyone shed some light onto how the oil seal goes in and out, Just take a screw driver to get it out ?
Is this all that is needed. http://www.ebay.co.uk/itm/PEUGEOT-306-DR...563c3d70eb
Like this^
I would Get one from the local pug garage, Is there anything else because i cant see how that would seal it ?
If anyone could Enlighten, me then please do!
On the 306 waiting list.