Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wanted: wheel boring contacts?
#3
(12-07-2013, 12:24 AM)Curt Wrote: If they're Ford fitment, you should need spacers? Usually 20mm. In which case you can get hubcentrics with the correct centre bore for the wheels and the hub.

The alloys I've got are ET16 mate so just right for the 306, its the centre bore which is smaller so needs boring out so it can fit over the hub :/

I can get 20mm conversion spacers that take a Ford wheel, but bolt onto the standard hub. But these will make it far too widely stanced as they're 7J, so already wider than the cyclones I've got on at the moment.
Reply
Thanks given by:


Messages In This Thread
wheel boring contacts? - by rtha6551 - 12-07-2013, 12:17 AM
RE: wheel boring contacts? - by Curt - 12-07-2013, 12:24 AM
RE: wheel boring contacts? - by rtha6551 - 12-07-2013, 12:32 AM
RE: wheel boring contacts? - by Danny2009 - 12-07-2013, 12:44 AM
RE: wheel boring contacts? - by rtha6551 - 12-07-2013, 12:52 AM
RE: wheel boring contacts? - by Piggy - 12-07-2013, 06:50 AM
wheel boring contacts? - by Sambarker - 13-07-2013, 04:00 PM
RE: wheel boring contacts? - by Chris - 13-07-2013, 04:59 PM
wheel boring contacts? - by rtha6551 - 14-07-2013, 10:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)