(11-07-2013, 10:53 PM)Poodle Wrote: Will need 20mm spacers with 65.1 female and 63.3 male spigot to achieve fitment as per standard. Those are an inch wider than standard, so to get your stance you'll probably need 15mm fronts and a 25mm rears, don't know if the clearance would be alright at the front on full lock like that though.
Thankyou
So I'll need
2 x 65.1 female
2 x 63.3 male
2 x 15mm front spacers
2 x 25mm rear spacers ?
(11-07-2013, 10:53 PM)Poodle Wrote: EDIT: Just seen he says et16 in the description, thought escorts were about 35, my bad. So yeah, in that case rears would need 5mm spacers and you'll need to bore out the centres to 65.1mm.
The rears just 5mm to get my desired stance? What about the fronts? Sorry I'm no good with offsets/bores etc
How much would I be looking at to get the centres bored? I assume I'd need to take them to a specialist machining shop? Then the same spigot rings you told me in the original post?
Thanks