04-07-2013, 05:29 PM
(This post was last modified: 04-07-2013, 05:38 PM by Welshy_Pete.)
(04-07-2013, 07:28 AM)cully Wrote: http://306oc.co.uk/forum/thread-11512-po...#pid228104
or
if its just one wire you could just cut out the 1 wire and solder a new piece in, if its not to close to the plugwhere its broken.
but remember to the insulate the joints, stick the rubber boot back together with superglue not sticking it to the wires
Hello thanks the information.
I've managed to rewire the door loom I've used electrical connectors just for now till everything working right. So its easy to swap any change wires if needed. I can soon change over to butt connections a lot smaller. I had problems due to the 2 smaller green wires and 2 purples wires being the same. There also 2 bage and 3 yellow. The wiring wasn't very good and the marking had warn out or wires no good in bits.
The 2 purple and 2 green smaller ones don't seem to make a difference which way around.
I looked at the mirrors wiring on both sides and window and speaker wiring to check were they were going wat colours etc. Then tested each one to get them working right.
There were colours of wires easy to match up of course.
I've managed to get the mirrors, windows and speaker all working good news. I'm not sure about the central locking motor.
I need to test the wiring on the socket plug for the central locking unit.
Also how about a test for the central locking unit?
I got 2 multi meters but not the best at using them so any help would be great thanks.
