|
Heater Matrix Removal
|
Posts: 4,604
Threads: 90 Joined: Dec 2011 Reputation: 54 Location: Cornwall Car Model/Spec: 1996 306 DT M-TDI/16 
Thanks: 0
Given 20 thank(s) in 18 post(s)
23-06-2013, 04:49 PM
The best thing you can do, is cut the two pipes off where the go through the bulkhead, get a piece of solid steel that the the pipes fit over, and drill a 5mm hole right thro it, so a small ammount of water can pass through.
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia | ![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Heater Matrix Removal - by Grant - 19-06-2013, 03:01 PM
RE: Heater Matrix Removal - by Niall - 19-06-2013, 03:03 PM
RE: Heater Matrix Removal - by Grant - 19-06-2013, 03:04 PM
RE: Heater Matrix Removal - by ginge191 - 19-06-2013, 03:06 PM
RE: Heater Matrix Removal - by Matt - 19-06-2013, 03:14 PM
RE: Heater Matrix Removal - by Niall - 19-06-2013, 03:14 PM
RE: Heater Matrix Removal - by ginge191 - 19-06-2013, 03:17 PM
RE: Heater Matrix Removal - by Grant - 19-06-2013, 03:15 PM
RE: Heater Matrix Removal - by Grant - 19-06-2013, 03:22 PM
RE: Heater Matrix Removal - by Niall - 19-06-2013, 03:26 PM
RE: Heater Matrix Removal - by Grant - 19-06-2013, 03:33 PM
RE: Heater Matrix Removal - by Niall - 19-06-2013, 05:10 PM
RE: Heater Matrix Removal - by Grant - 19-06-2013, 08:46 PM
RE: Heater Matrix Removal - by darrenjlobb - 19-06-2013, 09:01 PM
RE: Heater Matrix Removal - by Niall - 19-06-2013, 09:41 PM
RE: Heater Matrix Removal - by darrenjlobb - 19-06-2013, 09:58 PM
RE: Heater Matrix Removal - by joe1joe - 20-06-2013, 03:34 PM
RE: Heater Matrix Removal - by Ruan - 23-06-2013, 08:53 AM
RE: Heater Matrix Removal - by darrenjlobb - 23-06-2013, 10:27 AM
RE: Heater Matrix Removal - by Grant - 23-06-2013, 02:01 PM
RE: Heater Matrix Removal - by darrenjlobb - 23-06-2013, 04:49 PM
RE: Heater Matrix Removal - by Ruan - 23-06-2013, 06:10 PM
RE: Heater Matrix Removal - by Grant - 26-06-2013, 04:29 PM
|
