Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Very rough running
#6
(15-05-2013, 05:33 AM)DanWY Wrote: If air is getting in I'm not sure where it could be coming from as all the pipes are tight, unless its from the bottom of the housing.

The hand primer looks fine with no visible cracks or splits.

The engine is fine apart from this, only has 90000 or so miles on it.

bottom of the housing is very common, also check leak-off pipes and replace if need be, the housings also usually leak from the little white dial looking thing on the side . . hope this helps . .Smile
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:


Messages In This Thread
Very rough running - by DanWY - 14-05-2013, 09:11 PM
RE: Very rough running - by Ricky - 14-05-2013, 11:05 PM
RE: Very rough running - by DanWY - 15-05-2013, 05:33 AM
RE: Very rough running - by Mattcheese31 - 15-05-2013, 08:59 AM
RE: Very rough running - by Tom - 15-05-2013, 07:53 AM
RE: Very rough running - by DanWY - 15-05-2013, 08:38 AM
RE: Very rough running - by Tom - 15-05-2013, 09:21 AM
RE: Very rough running - by r3k1355 - 15-05-2013, 02:44 PM
RE: Very rough running - by DanWY - 15-05-2013, 05:45 PM
RE: Very rough running - by Tom - 15-05-2013, 06:02 PM
RE: Very rough running - by DanWY - 15-05-2013, 07:19 PM
RE: Very rough running - by DanWY - 18-05-2013, 10:20 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  rough idle very smoky blinkyeatu 3 1,609 03-07-2015, 03:01 PM
Last Post: blinkyeatu
  Rough start (misfiring) Dturbobooost 3 1,862 28-12-2014, 05:40 PM
Last Post: daddyfixit
  rough start up philpemberton94 7 2,234 15-08-2014, 01:49 PM
Last Post: ADV_93

Forum Jump:


Users browsing this thread: 1 Guest(s)