Ph1 xud in to ph3 hdi shell

[Chris_90]

sender is just for the fuel gauge mate

Oh will need you to have a look then some time see if mine is right one if not will get looking for clocks and sender unit.

Is there any thing else i will need??

can you use the heater matrix pipe off the hdi(the 2 pipes that come off the engine on to the bulk head)?? cos the one on the d turbo is fooked

Also what about imobliser on the hdi, will that affect any thing?

---

I think the only difference between the 2 engines are that the ph2 has a extra water pipe at the back of the block for the header tank

Could i use my phase 1 rad?? as it only just had a new nissens one so if i can swap that over at same time would be good