Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dash Board PCB
#8
the diode (d2) is connected between pins 7 and 14 on the yellow plug (20V JN)
it has effects on the oil pressure light and the stop light
i think it is probably component failure rather that external influence failure as the copper tracks on the board are still intact and not burned off!

the car should run without the dash connected but the stop light (pin 7) is controlled buy the ecu i believe, fingers crossed you have not fried the ECU!


.pdf   dash.pdf (Size: 163.64 KB / Downloads: 60)
Reply
Thanks given by:


Messages In This Thread
Dash Board PCB - by Anfrax666 - 10-04-2013, 10:50 AM
RE: Dash Board PCB - by darrenjlobb - 10-04-2013, 11:23 AM
RE: Dash Board PCB - by Anfrax666 - 10-04-2013, 11:32 AM
RE: Dash Board PCB - by Anfrax666 - 10-04-2013, 07:04 PM
Dash Board PCB - by Jonny b - 10-04-2013, 07:18 PM
RE: Dash Board PCB - by Anfrax666 - 10-04-2013, 07:50 PM
RE: Dash Board PCB - by cully - 12-04-2013, 08:13 AM
RE: Dash Board PCB - by cully - 12-04-2013, 09:56 AM
RE: Dash Board PCB - by Eeyore - 12-04-2013, 10:29 AM
RE: Dash Board PCB - by Anfrax666 - 12-04-2013, 11:43 AM
Dash Board PCB - by Jonny b - 12-04-2013, 11:49 AM
RE: Dash Board PCB - by Anfrax666 - 12-04-2013, 11:58 AM
RE: Dash Board PCB - by Anfrax666 - 18-04-2013, 09:44 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  1.6 Phase 3 Dash Board Issue Jama 3 3,057 09-09-2015, 02:05 PM
Last Post: Jama

Forum Jump:


Users browsing this thread: 1 Guest(s)