Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Another "Help" Torsion Bar Thread!
#10
I had this exact problem on Sunday!! On the same side. Ended up drowning it wd40 but found there was no room to swing a hammer. Eventually I used a small chisel and hammer but hit it in all directions to loosen it up...including hitting it face on. Would have used a blowtorch but didn't have mine to hand. Took about an hour to get it out. Good luck man...be brutal! Lol (and try not to wedge anything inside the hole in the washer as it damages the thread in the torsion bar.
Reply
Thanks given by:


Messages In This Thread
Another "Help" Torsion Bar Thread! - by 306Brad - 09-04-2013, 03:18 PM
RE: Another "Help" Torsion Bar Thread! - by Niall - 09-04-2013, 03:58 PM
RE: Another "Help" Torsion Bar Thread! - by Niall - 09-04-2013, 04:14 PM
RE: Another "Help" Torsion Bar Thread! - by Arron - 09-04-2013, 04:34 PM
RE: Another "Help" Torsion Bar Thread! - by Arron - 09-04-2013, 05:31 PM
Re: Another "Help" Torsion Bar Thread! - by floz123 - 09-04-2013, 06:04 PM
Another "Help" Torsion Bar Thread! - by JamesG - 09-04-2013, 07:27 PM
Another "Help" Torsion Bar Thread! - by Parksy87 - 09-04-2013, 08:07 PM
RE: Another "Help" Torsion Bar Thread! - by miles - 09-04-2013, 10:54 PM
Another "Help" Torsion Bar Thread! - by 306Brad - 10-04-2013, 07:11 AM
RE: Another "Help" Torsion Bar Thread! - by Piggy - 10-04-2013, 07:16 AM
Another "Help" Torsion Bar Thread! - by 306Brad - 10-04-2013, 07:19 AM
RE: Another "Help" Torsion Bar Thread! - by Matt - 10-04-2013, 07:32 AM
Another "Help" Torsion Bar Thread! - by 306Brad - 10-04-2013, 07:57 AM
Another "Help" Torsion Bar Thread! - by 306Brad - 10-04-2013, 02:58 PM
Another "Help" Torsion Bar Thread! - by 306Brad - 16-04-2013, 07:35 AM
Another "Help" Torsion Bar Thread! - by 306Brad - 16-04-2013, 09:26 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)