Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Advice and Input Needed :)
#5
Total overhaul of all serviceables - belts, fluids, filters, glowies (don't forget the ones in the pre-heating circuit), etc - unless your cambelt was done 10k ago or something. Doing the egr is a good shout too. Check your rubber piping for signs of deterioration.

Also clean up your engine bay, particularly any earth points. These cars are getting to the age now where corrosion is starting to make an appearance, best to nip it in the bud with a clean up and a fresh coat of paint. Got broken aircon? If so sack that off too.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:


Messages In This Thread
Advice and Input Needed :) - by JamesG - 20-03-2013, 08:48 PM
RE: Advice and Input Needed :) - by Piggy - 20-03-2013, 08:49 PM
RE: Advice and Input Needed :) - by Just Sean - 20-03-2013, 08:56 PM
RE: Advice and Input Needed :) - by DeeTurbo - 20-03-2013, 09:39 PM
RE: Advice and Input Needed :) - by Poodle - 20-03-2013, 10:51 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  306 HDI not starting, advice needed, fuel? sam-b 2 1,218 12-02-2014, 05:26 PM
Last Post: sam-b
  Gearbox input shaft bearing on the way out? JonT 7 3,270 14-10-2013, 06:55 PM
Last Post: JonT
  Turbo. Advice needed! Jonny81191 9 3,380 16-05-2012, 04:33 PM
Last Post: Jonny81191

Forum Jump:


Users browsing this thread: 1 Guest(s)