17-03-2013, 02:34 PM
(16-03-2013, 05:38 PM)Niall Wrote: Dont think so. Thanks though. Ruan will be looking over it tomorrow so im sure he can confirm what else we may need.
Today was spent replacing the ball joint it failed on. Sounds simple right? Oh no! We were going to change the whole wishbone but the front bolt was stupidly tight and eventually when it did give way, the threads gave way
Bought a new ball joint but the old one was riveted in. Took 3 hours with the limited tools we had to get it out and replace in the cold and wet. Still done now so will have a years ticket monday morning which means next weekend is full ahead go for the engine change
Limited tools?!
The two drills, angle grinder, blow torch and hammers we had, ontop of the standard tools such as sockets and jacks etc.
LOL
That said, i think props goes to Samass for lying under that thing near enough non stop. Team effort from everyone, but that bloke was relentless in getting it done. Well played to you sir.
![[Image: car-1.jpg]](http://i1117.photobucket.com/albums/k591/grant-306/car-1.jpg)
Member of the 99% warning or you're nothing club
2000 Moonstone 1.8 Meridian - Sold
2000 China 3dr XS - Dead
1998 Diablo 3dr XSI
