SALE INTEREST!! TD04 Adaptor plates

[CJ_Derv]

Just a quick update to keep people informed of recent issues which have now been rectified, we had a slight issue with the last 3/4 manifold plates as one of the threaded holes was out by a few mm which these have been replaced or buyer has managed to make fit with a little modification.

As for the elbow plates, these are still fine they may have used a 10mm drillbit instead of an 11mm bit so the holes may need opening a mm or 2.

But just to clarify what has been mentioned in previous posts the T2 application does need modification as one hole drilling right through and a nut and bolt or tapping as you can see in the picture as the elbow fouls where the stud would usually be