24-02-2013, 10:59 PM
The release bearing was clipped to the fork and I cable tied the arm to stop it flapping about when fitting the box.
I'm thinking it could be one of three things now,
1) It could be ether the bearing coming away from the fork when fitting the box.
2) The fork wasn't straightened enough and the bearing might be being pushed at an angle because of the mangled fork.
3) The plates in the wrong way but I'm starting to doubt this.
I also kept say to myself I must remember to fit it the right way but now I can't remember if I checked when fitting because I was trying to get everything nicely aligned.
Oh and Tom notice in the the first pic of the new clutch fitted the silver square on the right side of the fly wheel. It was that what was caught between the box and the block that stopped the bolt going in.
I'm thinking it could be one of three things now,
1) It could be ether the bearing coming away from the fork when fitting the box.
2) The fork wasn't straightened enough and the bearing might be being pushed at an angle because of the mangled fork.
3) The plates in the wrong way but I'm starting to doubt this.
I also kept say to myself I must remember to fit it the right way but now I can't remember if I checked when fitting because I was trying to get everything nicely aligned.
Oh and Tom notice in the the first pic of the new clutch fitted the silver square on the right side of the fly wheel. It was that what was caught between the box and the block that stopped the bolt going in.