31-12-2012, 02:14 PM
Some of you may have spotted my thread a couple of days ago about my brakelight bulbs, but this is not about them, they havent arrived yet.
When i bought the new bulbs, i purchased some LED bulbs for the reverse lights, and enough to do the indicators all round. Reverse lights are fine, and so are the rear indicators, but the LED bulbs dont seem to want to work in the front indicators. All the indicators just flash as if theres a bulb out. Does this mean i may need a resistor in the circuit? If so where would i have to put it?
Thanks in advance guys!
When i bought the new bulbs, i purchased some LED bulbs for the reverse lights, and enough to do the indicators all round. Reverse lights are fine, and so are the rear indicators, but the LED bulbs dont seem to want to work in the front indicators. All the indicators just flash as if theres a bulb out. Does this mean i may need a resistor in the circuit? If so where would i have to put it?
Thanks in advance guys!
![[Image: P1060836_zpsz3xgxt7q.jpg]](http://i1101.photobucket.com/albums/g427/wingnutz2/P1060836_zpsz3xgxt7q.jpg)