08-12-2012, 01:38 PM
Just putting Ben's clutch on and the friction plate/pressure plate line up with each other centrally fine, but they wont line up or sit central with the furthest hole in the end of the crank, as you can see in the below picture:
What silly thing are we doing wrong? Pressure plate obviously sits on the 3 locating dowels on the flywheel, flywheel is central on the crank.. :-S and if we rotate the pressure plate it will just be out of central by another 120*....
Halp
What silly thing are we doing wrong? Pressure plate obviously sits on the 3 locating dowels on the flywheel, flywheel is central on the crank.. :-S and if we rotate the pressure plate it will just be out of central by another 120*....
Halp