Right, I have been a busy bunny this morning and I believe I have removed all I can without making the car undrivable:
![[Image: P1010019-2.jpg]](http://i145.photobucket.com/albums/r233/Flynn_bucket/P1010019-2.jpg)
The only thing I have had problems with are the heater controls:
![[Image: P1010017.jpg]](http://i145.photobucket.com/albums/r233/Flynn_bucket/P1010017.jpg)
The Haynes just says to unclip them but I can't find out how to do so.
Also, is there a way to tell the heater matrix type before exposing it, like looking at the pipe fitting for instance? I would rather get one ordered so that it is ready for when I have the dash out.
Edit: Also is it worth splashing out for an expensive one or should I just buy a bargain basement one? I don't want to have to do it again in another two years.
The only thing I have had problems with are the heater controls:
The Haynes just says to unclip them but I can't find out how to do so.
Also, is there a way to tell the heater matrix type before exposing it, like looking at the pipe fitting for instance? I would rather get one ordered so that it is ready for when I have the dash out.
Edit: Also is it worth splashing out for an expensive one or should I just buy a bargain basement one? I don't want to have to do it again in another two years.