306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
GT2056 fitting q's

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GT2056 fitting q's
zx_volcane Offline
Living for the ZX

Registered users - Donated
Posts: 3,662
Threads: 127
Joined: Feb 2012
Reputation: 33
Location: London
Car Model/Spec: ZX Volcane TD
Thanks: 6
Given 32 thank(s) in 32 post(s)
#14
02-11-2012, 10:48 PM
Can you get some local place to cut you some holes of the right diameter and then you do the rest? Then at least you don't have to wait for them to faff about lining everything up and sorting it out. I left my last set of plates square shaped :/
Team ZX

Arduino controlled huge turbo'd XUD'd ZX

^click for project

[Image: avatar_zpstlcgvhg8.jpg]
Find
Reply
Thanks given by:


Messages In This Thread
GT2056 fitting q's - by cwspellowe - 01-11-2012, 10:10 PM
RE: GT2056 fitting q's - by Dave - 01-11-2012, 10:22 PM
RE: GT2056 fitting q's - by cwspellowe - 01-11-2012, 10:23 PM
RE: GT2056 fitting q's - by Jake - 01-11-2012, 11:22 PM
RE: GT2056 fitting q's - by padge - 01-11-2012, 11:50 PM
RE: GT2056 fitting q's - by Ruan - 02-11-2012, 08:46 AM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 09:12 AM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:06 PM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 10:11 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:12 PM
RE: GT2056 fitting q's - by Harky - 02-11-2012, 10:17 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:18 PM
RE: GT2056 fitting q's - by Harky - 02-11-2012, 10:46 PM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 10:48 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:58 PM
RE: GT2056 fitting q's - by Ruan - 03-11-2012, 07:01 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)