01-01-2012, 10:49 PM
Ruan yes I was talking generally. XUDs arent my specialty.
correct me if im wrong here but you still dont have a FMIC and I suspect your running a little more boost than Mr Flynn is aiming for which is what causes your massive EGTs
I get what your saying about the duration needed to haze on full power but lower boost = less oxygen = less duration and flow to achieve hazing.
Flynn the 2 bits you will most likely break if your doing a gov mod are the cradle and the top cap of the governor itself (the bit the circlip holds back) it has 4 tiny little legs and theyer f*cking easy to snap off.
Most small washers are 0.8mm thick, I used 4 of them when I did mine making 3.2mm and it revved all the way to 6k It would of gone more but i pussied out. These people shimming 9mm pumps and standard turbos 4+mm are wasting their time as the turbo is right out of its efficency range past 5k and the harder the gov is sprung the more likely something is to break as there is more pressure in the spring.
correct me if im wrong here but you still dont have a FMIC and I suspect your running a little more boost than Mr Flynn is aiming for which is what causes your massive EGTs
I get what your saying about the duration needed to haze on full power but lower boost = less oxygen = less duration and flow to achieve hazing.
Flynn the 2 bits you will most likely break if your doing a gov mod are the cradle and the top cap of the governor itself (the bit the circlip holds back) it has 4 tiny little legs and theyer f*cking easy to snap off.
Most small washers are 0.8mm thick, I used 4 of them when I did mine making 3.2mm and it revved all the way to 6k It would of gone more but i pussied out. These people shimming 9mm pumps and standard turbos 4+mm are wasting their time as the turbo is right out of its efficency range past 5k and the harder the gov is sprung the more likely something is to break as there is more pressure in the spring.