Front ARB Bushes
|
Front ARB Bushes
|
Posts: 28
Threads: 9 Joined: Apr 2017 Reputation: 0 Location: Frodsham Car Model/Spec: Peugeot 306 gti-6 Thanks: 4
Given 0 thank(s) in 0 post(s) Country: 
28-06-2017, 11:08 AM
Hello all I am currently fitting new Front arms to my GTI-6 whilst doing this I thought about replacing the ARB Bushes as they are 17 years old and done 114k.
Is it worth it as I have seen threads they are poly from Factory also are they a pain to change over do you require any grease etc? 
28-06-2017, 11:40 AM
Im sure a bit of grease wouldnt hurt. I havent really heard of anyone replacing theirs. Should be fairly easy to do.
28-06-2017, 11:56 AM
Had mine replaced at 165k miles, and they were still fine, definately worth doing to freshen up the front end though.
28-06-2017, 01:45 PM
28-06-2017, 04:16 PM
Hard to tell Sam, had the full front end suspension replaced at the same time, but probably.
28-06-2017, 07:23 PM
I replaced mine. The old ones barely looked worn.
I wouldn't bother as it is very fiddly, and they are indeed poly from factory.
This post is an artistic work of fiction and falsehood. Only a fool would take anything posted above as fact.
62k Diablo Phase 1 Gti-6: Project Thread
Posts: 28
Threads: 9 Joined: Apr 2017 Reputation: 0 Location: Frodsham Car Model/Spec: Peugeot 306 gti-6 Thanks: 4
Given 0 thank(s) in 0 post(s) Country:
30-06-2017, 08:13 AM
Thanks for the input guys I have had a look and they don't look great Lemforder ones are cheap enough so whilst I have the arms off I will change these out to. Any tips for removing them I see they fit in a specific position.
30-06-2017, 08:49 AM
Removing them is ok, once the droplinks are disconnected you can wiggle the ARB a lot. Refitting them is tricky, the brackets holding them down bolt down to the subframe through the p-bush as I am sure you can see.
The rear of the bracket just has a hook on it. It is difficult to get this hook in, and then pull the front down enough to get it through the bolt. With the subframe off I imagine it is easy to build it all up and then put the whole assembly on the car. With it fitted the clearance isn't great. It is possible, just a PITA, but then I never was good at fiddly things!
This post is an artistic work of fiction and falsehood. Only a fool would take anything posted above as fact.
62k Diablo Phase 1 Gti-6: Project Thread
Posts: 28
Threads: 9 Joined: Apr 2017 Reputation: 0 Location: Frodsham Car Model/Spec: Peugeot 306 gti-6 Thanks: 4
Given 0 thank(s) in 0 post(s) Country:
30-06-2017, 12:14 PM
Thanks for the info im sure I will have fun with this over the weekend.
Posts: 28
Threads: 9 Joined: Apr 2017 Reputation: 0 Location: Frodsham Car Model/Spec: Peugeot 306 gti-6 Thanks: 4
Given 0 thank(s) in 0 post(s) Country:
03-07-2017, 09:59 AM
Well new ARB Bushes fitted very fiddly but with patience they are not too bad. The drivers side one was knackered passenger side still stiff.
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Powerflex Front Wishbone Bushes | gti6man | 2 | 2,303 |
16-11-2017, 09:36 PM Last Post: miles |
|
|
Front arb bushes sizes | Welshy_Pete | 0 | 919 |
22-12-2013, 12:23 AM Last Post: Welshy_Pete |
| Front anti-roll bar bushes | Ben | 22 | 7,065 |
18-09-2012, 05:57 PM Last Post: puglove |
|
