TD04L Inlet Size

[silverzx]

Is it 49mm? I know its smaller then T25 but I can't remember the TD04 and don't think a pair of calipers will fit down there very well!

I want to get some air filter piping sorted and need to know!

Thanks whoever!

[bigcheez2k3]

51mm I think I measured mine at.

[silverzx]

Hmm, maybe I've confused myself.

Thought T25 was 51mm and TD04 < 50. Perhaps T25 is more like 54mm and TD04 51mm as you say.

[cwspellowe]

Just get a 2" reducer for it, will tighten down with a clamp anyway

[martyn92]

Mine is 55mm :-)

[silverzx]

Mine is 55mm :-)

I'll just try ram some callipers down there... lol.

[Jonny81191]

The standard T2 intake pipe will just fit with a little persuasion.

[silverzx]

The standard T2 intake pipe will just fit with a little persuasion.

Ok well pretty sure thats 49mm but can check, I'll figure it out.

[darrenjlobb]

Run the BIGGEST pipe you physically can to it if your not running it open filter, the inlet pipe will restrict the turbo more than anything else on the entire induction / boost system, 30cm of pipe of the same size as the turbo inlet will be hugely restrictive, granted theres is shag all room down the back of an xud to run anything much bigger, hence most get left open, but its well worth trying!

[silverzx]

Run the BIGGEST pipe you physically can to it if your not running it open filter, the inlet pipe will restrict the turbo more than anything else on the entire induction / boost system, 30cm of pipe of the same size as the turbo inlet will be hugely restrictive, granted theres is shag all room down the back of an xud to run anything much bigger, hence most get left open, but its well worth trying!

Hmm, can't see anything bigger then 2.5" flexi fitting where I want to run it..