Mikalor Style Clamps

[Just Sean]

As title, where from?

I cant use paypal atm as theyve blocked my account pending verification of my address.

[Midnightclub]

B and q? If not then eBay.. You can still Just pay by card instead of PayPal

[Just Sean]

bnq ... really?

---

Dont look very strong!

[Midnightclub]

Can't see any reason why they wouldn't? Told you the leak was off the turbo

[darrenjlobb]

doubt b n q will have them....

My local hydrolic fitting place sells them...you maybe have something similar near by?

That said, I acaully personally hate the genuine mikalor ones, I dont like the style with bolt and built in nut, the ones with built in bolt and a nut (ebay chinease copies) work far better, and the thinner stainless band flexs to fit the pipe much better, not often id say it, but i find the cheap copies much better than the genuine ones!

[Just Sean]

Intresting! Might get some cheap ones then. Will try ebay if i can pay via debit card

---

Are these cheap enough darren?

http://www.ebay.co.uk/itm/Jubilee-Worm-D...27c62f3073

[Just Sean]

Need paypal for those ones anyway! Grrr

[Harky]

Pretty sure those are just your normal jubilee clamps, which slip when you try to tighten them too tight... You might have to splash out a wee bit more!

[swampy]

Yep those are jubilee clips, for boost you want Mikalor or copies there of

[HDIkyle]

Use ASH you posted in another thread, I get mine from there called T bolt clamps

[Just Sean]

http://www.tom-parker.co.uk/products_sub...oups=4165B

Got these. 40 - 43mm. Should be right. Its for the turbo 90degree elbow

[Midnightclub]

perfec

[darrenjlobb]

U need the ones with cranked bolts and thin retainer plate, or else they have to be the exact size / never work right / will drive you insane if your silicon is thicker on some than other.

[Toms306]

They are such a pita to size properly, bought 3 before I got one the right size because they have so little adjustment! I also used the ASH ones though...

[Just Sean]

Aslong as i can get it nice and tight it shouldnt leak anyway. The hose is 38mm diameter and the inlet on the turbo is 41mm... It might be leaking at the 90degree to c5 lower pipe end as iirc theyre both 41mm... IF 40mm is too big then its only a quid or so for the size smaller.

[darrenjlobb]

They are such a pita to size properly, bought 3 before I got one the right size because they have so little adjustment! I also used the ASH ones though...

The problem is you have to alow for silicon as well...which makes it confusing, say you have a 63mm pipe, a 63mm clamp will be a **** to get on once silicon is in situe, or at least it is if you use quality thick silicon anyway..

[Toms306]

Yeah I realised that after the first one....2nd one was too big though instead!