02-10-2012, 09:37 AM
I got some front bearings for a phase 2 DT Sedan. But have been sent ones with the smaller locking nuts. My question is are they all the same? I have checked the size of the ones i have to ones listed for my reg on GSF site and they match however on ECP they are listed larger than mine?
Will these fit ok? I was to hope it was the center of the hub that differed and the bearings would be the same?
Will these fit ok? I was to hope it was the center of the hub that differed and the bearings would be the same?
TD04 11mm Sedan, now 2.1 vnt
Sedan Project http://306oc.co.uk/forum/thread-5763.html
Provence Dturbo Dead
Blaze 1.6 Dead
China 5dr '6 Death by cambelt failure
Matt White HDI estate Death by wiring
Sedan Dturbo aka triggers broom
Diablo estate Dturbo Living dead
Sedan Project http://306oc.co.uk/forum/thread-5763.html
Provence Dturbo Dead
Blaze 1.6 Dead
China 5dr '6 Death by cambelt failure
Matt White HDI estate Death by wiring
Sedan Dturbo aka triggers broom
Diablo estate Dturbo Living dead