Posts: 107
Threads: 16
Joined: Jul 2014
Reputation:
0
Thanks: 7
Given 1 thank(s) in 1 post(s)
Another one for the zx and maybe 306 lot
I'm replacing the front left bearing (comes with nut) and my rear brake cables are due a change,
Does the Zx use reusable hub nuts or are they the type you replace
Posts: 16
Threads: 3
Joined: May 2015
Reputation:
0
Location: Oxon
Car Model/Spec: ZX XUD9 (sorry...)
Thanks: 0
Given 0 thank(s) in 0 post(s)
Country:
When I did the reasr bearings on my old 1.4 ZX with drums the nut was reuseable afterwards, so was the cap after a bit of tapping back in to shape.
No idea if it should be reusable ot not but I still see it locally and it's not been off again (it took a few chisel taps as I got the cap off and I lined the marks back up, they havent moved)
Posts: 6,367
Threads: 87
Joined: Dec 2011
Reputation:
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
Given 74 thank(s) in 70 post(s)
The back ones are one use but...... If you swap them to the other side of the car it will give you a fresh piece of nut to stake into place, the fronts are reusable
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Posts: 6,367
Threads: 87
Joined: Dec 2011
Reputation:
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
Given 74 thank(s) in 70 post(s)
That's the one fella yes,
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Posts: 6,367
Threads: 87
Joined: Dec 2011
Reputation:
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
Given 74 thank(s) in 70 post(s)
Haha yes it's pikey, hub nuts are only a few quid each but it's good to know if u cant get hold of any and you need to work on the drums
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs