Went in to get my new full exhaust fitted today. About 30 mins later guy calls me out to see 'a problem'. Can't get the downpipe nuts off he says. They're just spinning. Yeah, that's because they have a bolt head mate. Tried putting a socket on the heads? Oh.... I didn't realise .. ffs
Then "all done", wee bit of a blow they say, cause theres no gasket. Errr, there should be a mesh gasket.. Ah, didn't send one over. Was blowing like fook. Going back tomorrow to get the gasket added. Plus when it was in on Tuesday to verify the correct exhaust to order, the young lad that drove it in cranked the engine for ages before it started both times. Glow plugs eh? I say to him sarcastically - cue confused look
Then "all done", wee bit of a blow they say, cause theres no gasket. Errr, there should be a mesh gasket.. Ah, didn't send one over. Was blowing like fook. Going back tomorrow to get the gasket added. Plus when it was in on Tuesday to verify the correct exhaust to order, the young lad that drove it in cranked the engine for ages before it started both times. Glow plugs eh? I say to him sarcastically - cue confused look
