Peugeot 306 Hdi modified

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Peugeot 306 Hdi modified
#1
Hi all ask any questios you wish or check out my project thread...

£1300 ono

Peugeot 306 Hdi dturbo

Half leather seats in good condition - drivers bolster was re sueded in 2011 (front bases are phase 1 and front rears,which supports your back are from phase 3 so your feel a more hugged sensation)
Lowered 45mm rear
Lowered 40mm front - Gmax shocks(will check) and bilstien springs
Decate exhaust system with 2.5inch rear pipe - has a middle silencer and back box only
Footwell neons
Brand new handbrake cables (13/10/2012)
FMIC - with a stage 1.5map on it - will give stage 2 map with the full £1300 (Mr Whippy remap) - pushing approx 140bhp ???lb/ft
Aircon rad removed
Cupra R splitter
Set of 5 Ariane alloys 4 in good condition (comes with 4 centre caps) - 1 tyre is legal limit all rest are above. - spacers on rear
12months MOT
6months tax
Halo angel headlights
Flushed smooth boot(installed boot popper) + colour coded spoiler
GTI6 283mm front yellow callipers - Fronts brand new discs and pads(11/10/2021),
Rear discs and pads brand new (12/10/2012)
Handbrake cables brand new (12/10/3012)
Griffiths Engineering Quikshift fitted along with shortened gear stick
Metal Monkey heater dails (worth £20 alone)
Metal Monkey speedo clock (worth £100) - "Batman style"
Pug racing gear linkages (Fitted August)
Gear stick Short shifter (Griffiths Engineering)
New windscreen (Fitted August)
electric boost gauge
additional 12V added by steering wheel
colour coded windscreen wipers
wind deflectors
Fli6 comps and tweeters
Stealth shelf with Sony 6x9 still hidden
Boot tidys
air filter
de egr'd



Rear beam is 2nd hand - beam has had new bearings in both sides - has new bilstein dampers
new alternator in 2010
new top mounts and bearings in 2009
brand new clutch in 2009
gearbox(2nd hand) in 2009
Last oil,fuel filter change was August 2012 with pug parts and 5w 15 full synth oil
new crankshaft pulley 2009
new aux tensioner and belt
new wishbones 2009
black interior refresh

[Image: IMG_2317.jpg]
[Image: 43f706ef.jpg]
[Image: ee54aabc.jpg]
[Image: 124343f3.jpg]
[Image: 3d731c90.jpg]
[Image: IMG00529-20110126-1549.jpg]
[Image: IMG_2350.jpg]
[Image: 52efc5ff.jpg]
[Image: bootsmooth.jpg]
[Image: 7b6073a2.jpg]
[Image: IMG00293-20100610-2254.jpg]
[Image: metaldialsday.jpg]
[Image: 100_0823.jpg]


UPDATE - Service History

Has Garage stamps up until 114k - timing belt done at 96k. Current mileage 128k

All repairs,mods done to car has service receipts from local garages and i have a documented list on what ive done to it available when buyer views.

Regularly oil changed at 6-8000miles since my ownership (3years),this includes air filter,fuel and oil filter.

pics -
[Image: IMG_27931_zpsf9805bf2.jpg]
[Image: IMG_27921_zps246f9b71.jpg]

It does have previous history before 77k all stamped in the book also

deposit welcome minimum £300
Test drive welcome after 5pm
Visit any time (when im free)

Thats all i can think of for now..feel free to browse my Project thread or ask any questions pm me

Will not come with CD PLAYER unless I find a cheap one to put in

cheers

Ben

ask any questions ask below...

BAD POINTS
needs drivers door hinge
[Image: 6dff5703.jpg]

Will get some more pics today as there is a parking ding or 2 ( all before I owned it)
Scratch on the side panel but with a decent polisher it can be hidden better, ive polished it up but in the flesh you can still see it..
Before :
[Image: IMG_2198.jpg]

After 1 polish
[Image: IMG_2201.jpg]

Dent on bonnet just above the pug badge
[Image: Image025.jpg]
[Image: sig.jpg]
Reply
Thanks given by:
#2
Very nice, good luck with sale.
Reply
Thanks given by:
#3
Didn't think people could post in here..hmm

Cheers anyways fella,it's done my good but time to sell up and move on Smile
[Image: sig.jpg]
Reply
Thanks given by:
#4
You're thinking of the wrong forum Ben Tongue
Reply
Thanks given by:
#5
Scott can you copy and paste all the replies over and close that thread then pls?
[Image: sig.jpg]
Reply
Thanks given by:
#6
If car I view on Wednesday is bought this car will have NO TAX.

But will tax it for buyer price dependent
[Image: sig.jpg]
Reply
Thanks given by:
#7
Update- now has brand new handbrake cables and rear docs and pads
[Image: sig.jpg]
Reply
Thanks given by:
#8
£1300 it will come with upper and lower strut brace,HIDS and 6months tax


deposit welcome minimum £300
Test drive welcome after 5pm
[Image: sig.jpg]
Reply
Thanks given by:
#9
If i had the money i'd be on this like a tramp on chips, one of the tidiest i have seen.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
#10
cheers Poodle - get a loan Smile as said i can keep hold of a deposit if you need a bit longer to get rest of the cash

will keep for a maximum of a month with a non refundable deposit

if car still with my after a month i keep the car and deposit Smile
[Image: sig.jpg]
Reply
Thanks given by:
#11
UPDATE - Service History

Has Garage stamps up until 114k - timing belt done at 96k. Current mileage £128k

All repairs,mods done to car has service receipts from local garages and i have a documented list on what ive done to it available when buyer views.

Regularly oil changed at 6-8000miles since my ownership (3years),this includes air filter,fuel and oil filter.

pics -
[Image: IMG_27931_zpsf9805bf2.jpg]
[Image: IMG_27921_zps246f9b71.jpg]

It does have previous history before 77k all stamped in the book also

cheers
[Image: sig.jpg]
Reply
Thanks given by:
#12
12months MOT as of today! Smile
[Image: sig.jpg]
Reply
Thanks given by:
#13
Brand new handbrake cables fitted over the weekend
[Image: sig.jpg]
Reply
Thanks given by:
#14
Rolling Road before adding the FMIC,car now has FMIC and on a stage1.5map . i do have the stage 2 map on my laptop for the buyer (Mr Whippy)
Turbo needs to be wound up -

[Image: 84D1464E-4805-4CFB-9D05-243B2237697C-458...DFA9B9.jpg]
[Image: BCF98F3F-C034-46D6-B36A-5C466A944D46-458...379DCC.jpg]
[Image: sig.jpg]
Reply
Thanks given by:
#15
new pics today....
No EML or any other warnings:
[Image: th_IMG_2821_zpse20eff24.jpg]

[Image: IMG_2806_zps4b43a863.jpg]
[Image: IMG_2807_zps99e8150e.jpg]
[Image: IMG_2808_zps76fe1ac9.jpg]
[Image: IMG_2809_zpsceb46c31.jpg]
That rear wheel is my spare and i do have the centre cap the the other alloy,just not swapped them back round

[Image: IMG_2810_zps82b98840.jpg]
not deep,needs a polish and the worst of it will come up and fade,polished it twice and faded loads

[Image: IMG_2811_zps008085e8.jpg]
bonnet damage

[Image: IMG_2812_zps05315a59.jpg]

[Image: IMG_2813_zps90649787.jpg]
bit of paint missing on the rear just below boot lid

[Image: IMG_2814_zps550be176.jpg]
centre cap for this alloy is in the glove box - comes with boot tidys but not items in boot (except alloy) needs to go in the cage but cant be bothered lol

[Image: IMG_2815_zps7a621dce.jpg]

[Image: IMG_2816_zps6fdcbf29.jpg]
just cleaned seats so there is a 3rd belt but hidden same as clip

[Image: IMG_2817_zpsc8db0ddc.jpg]
backs of seats are phase 3, bottoms are phase 1 (hugs more) yes i did buy phase 1 and 3 seats just to do that lol)
also been resuded so no wear and tear

[Image: IMG_2818_zps15eaa1aa.jpg]

[Image: IMG_2819_zpsa9dfc6d8.jpg]



Hope it helps !
[Image: sig.jpg]
Reply
Thanks given by:
#16
SOLD SOLD SOLD SOLD SOLD
[Image: sig.jpg]
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 1 Guest(s)