Wheel Bolts

[carlukepeugeot]

Hi folks,

Apologies if this is the wrong section, was just looking to pop it into an active section as time is a factor. Getting some refurbed cyclones shortly and wondering how to identify which bolts I need. Basically is there a part number or other ID (eg cyclone 2 or something) on the wheels that I can go by? I currently have standard Dturbo alloys on the car.

Many thanks!

Craig

[welshpug]

if you have the correct bolts on the harriers they will be correct for cyclones.

[Toms306]

Some of the later cyclones had a partial taper on the bolts, but the straight bolts from earlier alloys fit both types.

[carlukepeugeot]

Thanks guys.

[Nexus]

I've got a late 2001/2002 Phase 3 with cyclones as standard. I'm using the following bolts:

   

Purchased these from your usual well known auction website at a very reasonable price for a full set (obviously consider some locking wheel nuts). I've had them on for a year or two and have been really nice quality, haven't faded or scratched from using sockets on them. Really compliment the refurbed wheels.

[carlukepeugeot]

I've got a late 2001/2002 Phase 3 with cyclones as standard. I'm using the following bolts:



Purchased these from your usual well known auction website at a very reasonable price for a full set (obviously consider some locking wheel nuts). I've had them on for a year or two and have been really nice quality, haven't faded or scratched from using sockets on them. Really compliment the refurbed wheels.

Brilliant information. Thank you!

Edit: found the very ones in the picture...