|
A Post Loom
|
28-03-2015, 01:29 PM
New to the forum and looking for advice, bought myself a 306 d turbo, but it has the typical a post door loom issue. Is there any hope of hard wiring the door loom to the chassis one or will I have to get the repair kit from Peugeot?
Posts: 6,367
Threads: 87 Joined: Dec 2011 Reputation: 48 Location: South Yorks. Car Model/Spec: Rouge vallelunga 5 door Dturbo 
Thanks: 2
Given 74 thank(s) in 70 post(s)
28-03-2015, 01:32 PM
Get a Stanley knife, extra wire, soldering iron, electrical tape and get stuck in mate.....standard issue lol
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
28-03-2015, 01:39 PM
Got a diagram of which wire goes where? Mine didnt even have the connectors on the end of each loom so at a lost lol.
Posts: 7,825
Threads: 465 Joined: Dec 2011 Reputation: 114 Location: Cullompton Devon Car Model/Spec: Vauxhall 
Thanks: 1
Given 98 thank(s) in 92 post(s) https://www.check-mot.service.gov.uk/ GTI6 Info Don’t drive faster than your guardian angel can fly.
28-03-2015, 03:23 PM
No, im asking for help hardwiring the looms together without the need for a connector.
28-03-2015, 03:25 PM
http://306oc.co.uk/forum/showthread.php?tid=11512
Have a read and if you're put off by it, don't be put down. It's quite a task..
Diablo Hdi Dturbo and 205 1.9 project - it lives!
28-03-2015, 04:23 PM
Sorry if I didnt make it clear, I wish to know how to HARDWIRE the looms together without using the connector
Posts: 7,825
Threads: 465 Joined: Dec 2011 Reputation: 114 Location: Cullompton Devon Car Model/Spec: Vauxhall
Thanks: 1
Given 98 thank(s) in 92 post(s)
28-03-2015, 04:26 PM
if you do that you wont be able to remove the door without cutting the loom wire
https://www.check-mot.service.gov.uk/ GTI6 Info Don’t drive faster than your guardian angel can fly. |
|
« Next Oldest | Next Newest »
|
