Pulling left and right

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pulling left and right
#1
Been out and about today and had an issue develop on the 6

Was fine for most of the day parked up and when i set off noticed Whenever i accelerate the car pulls to the right and when i lift off pulls left


Could it be a tracking problem or something more serious? I know the top engine mounts not great...
Reply
Thanks given by:
#2
Sounds tracking.

Get it done professionally for an accurate result ThumbsUp
Diablo Hdi Dturbo and 205 1.9 project - it lives!
Reply
Thanks given by:
#3
wishbones moving= p bush gone to meet its maker ??

check/replace and only then get the tracking done
Reply
Thanks given by:
#4
I would likewise go with P-bushes. Had similar symptoms when mine separated from the housing. Tracking would cause problems in one direction, not both.
[Image: car-1.jpg]

Member of the 99% warning or you're nothing club


2000 Moonstone 1.8 Meridian - Sold
2000 China 3dr XS - Dead
1998 Diablo 3dr XSI
Reply
Thanks given by:
#5
Seems to only have the issue when turning right or going straight, left is fine

Estimated cost of p bushes and best place to buy?
Reply
Thanks given by:
#6
(15-07-2013, 07:24 PM)rocker8742 Wrote: Seems to only have the issue when turning right or going straight, left is fine

Estimated cost of p bushes and best place to buy?

I'm having exact same issues at the mo, p-bushes are cheap (about£12) but you need a press to get them in. Check the bolts that hold the wishbone on by the p-bush as well as my bolt had sheared off completely creating even more wobble under load and braking.
Reply
Thanks given by:
#7
Had them swapped over yesterday and apparently the captive nut had sheared off aswell
Reply
Thanks given by:


Possibly Related Threads…
Thread Author Replies Views Last Post
  Reasons for pulling to left? lolsteve 37 9,423 26-06-2014, 10:12 PM
Last Post: Jtrigga
  Pulling to the right Niall 47 17,135 14-11-2013, 06:39 PM
Last Post: Ican

Forum Jump:


Users browsing this thread: 1 Guest(s)