28-04-2018, 07:39 PM
I've got wildwood calipers. I ordered an adapter which was the correct NPT thread which wound into the caliper inlet and the other end is M10 male (pictured).
I then ordered brake lines and specified female M10 swivel fittings for both ends (also pictured).
I'm not sure they will fit the adapter on the caliper (shown), or the standard male fitting on the car. Anyone able to give any guidance on this?
I then ordered brake lines and specified female M10 swivel fittings for both ends (also pictured).
I'm not sure they will fit the adapter on the caliper (shown), or the standard male fitting on the car. Anyone able to give any guidance on this?
This post is an artistic work of fiction and falsehood. Only a fool would take anything posted above as fact.
62k Diablo Phase 1 Gti-6: Project Thread
62k Diablo Phase 1 Gti-6: Project Thread
