14-02-2018, 10:41 AM
(This post was last modified: 14-02-2018, 10:52 AM by pug306driver.)
This is the ducting for the heater air, but how does it come off please. The Haynes book says its rubber, it aint, and it just comes off, it don't. It seems solidly fixed.
I found a shaped bit of drain hose with a 90 degree bend in that area and can feel 2 clips for it to clip into, but cannot feel the stub for it to fit over and direct drain water away, thru the large drain hole ?
Maybe there are 2 studs/nuts inside under the dash a bit like the other side of the scuttle, the main wiring loom that goes thru the scuttle. Help please.
I need to remove this bit to make sure there are no holes underneath it that will allow water into the cabin. The carpet is not wet as such but its not bone dry either.
Need to illuminate all water leaks as still having water/damp related central locking/immobiliser problems !!! grrrrrrrr.
Also, what is this connector for please, the wire seems to disappear under the wing. Its by the ecu/intertia switch/fuel double relay/coolant heater plugs relay box area.
Have narrowed down the water leak by the rear off side cuddy in the rear of the estate, seems to be either coming thru window seam, or thru roof rail central mounting or past the upper weather seal area. It may run down inside door pillar into electronics box to do with central locking at bottom of driver door pillar ??
fun and games grrrrrrr.