Fmic installation advice

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fmic installation advice
#1
Needing some advice fitting a front mounted intercooler and any advice build threads photos of what people have done. To start off with what do people do with the fans on the radiator can you switch the radiator round or use a different one off another car? 

Secondly looks tight to fit I know some have had the pipes coming from on end above or under the intercooler would prefer not to cut but ready to fit once I've got a bit of advice as it will be my first attempt at fitting one


Attached Files Image(s)
   
Reply
Thanks given by:
#2
Try these links, there are other threads too perhaps with even more info / photos

mods fancy sticking this thread in the correct section?

http://306oc.co.uk/forum/showthread.php?tid=15971

http://306oc.co.uk/forum/showthread.php?tid=8172

http://306oc.co.uk/forum/showthread.php?tid=29759
Reply
Thanks given by:
#3
Thanks bud what manifolds do people tend to run with I've been offered a xantia from a bloke round the corner but was just going to stick with the pug one and run a td04

And fitting a dual pass fmic do you get any extra lag ? Or isn't there much difference between them ?

Just reading the threads and there fore hdi's is there any difference between them and a Xud do I stil need the 406 manifold and turbo pipe or can I use the xud one or a xantia ?
Reply
Thanks given by:
#4
(19-11-2015, 11:37 AM)ashdturb Wrote: Thanks bud what manifolds do people tend to run with I've been offered a xantia from a bloke round the corner but was just going to stick with the pug one and run a td04

And fitting a dual pass fmic do you get any extra lag ? Or isn't there much difference between them ?

Just reading the threads and there fore hdi's is there any difference between them and a Xud do I stil need the 406 manifold and turbo pipe or can I use the xud one or a xantia ?

Xantia is the most popular choice Smile if you can get one locally then do it Smile
Reply
Thanks given by:
#5
Can get the xantia mani for £30 do I need a 406 turbo pipe as the thread suggest for a hdi with mine being d t?
Reply
Thanks given by:
#6
No those parts are different from hdi/xud..

Hdi guide is ok for front end though
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 1 Guest(s)